Message boards : Server and website : No receives WU's
Author | Message |
---|---|
Hello, after the completion of my last WU (my second WU in this project), BOINC requests a new one and always receives the message "GPUGRID Scheduler request completed: got 0 new tasks". | |
ID: 19808 | Rating: 0 | rate: / Reply Quote | |
Your computer is hidden. The CA's (and other crunchers) can not advise without being able to see your setup. | |
ID: 19812 | Rating: 0 | rate: / Reply Quote | |
Ok, i modified my computer visibility. | |
ID: 19813 | Rating: 0 | rate: / Reply Quote | |
Computers hidden | |
ID: 19814 | Rating: 0 | rate: / Reply Quote | |
Computers hidden It always takes a while for an 'unhide' change to take effect. Try looking again a bit later. | |
ID: 19816 | Rating: 0 | rate: / Reply Quote | |
The GT 330M is basically a clocked down mobile version of the GT220. It only has 48 cuda cores and is not a recommended GPU for running GPUGrid; it can just about complete a task within 48h. You had one task error after 6.20 sec. This is not a problem; as it would not effect your overall contribution. The two tasks you completed were very slow. I suggest that if you wish to continue to crunch on that system that you use swan_sync=0 and also keep one CPU core/thread free. Also make sure your cards Power management is set to Prefer Maximum Performance (NVidia control panel, Manage 3D settings, Power management mode). | |
ID: 19819 | Rating: 0 | rate: / Reply Quote | |
I understand. But how i can leave one thread free? in BOINC settings? if configure boinc to use 75% of cores (3 of 4) GPU will use it?. | |
ID: 19823 | Rating: 0 | rate: / Reply Quote | |
Yes, in Boinc Manager use 75% of CPU cores means one core/thread is free for a quad core/thread CPU. You should also use swan_sysn=0, keep a low cache and report tasks immediately. | |
ID: 19825 | Rating: 0 | rate: / Reply Quote | |
Message boards : Server and website : No receives WU's